Year Built

Check firstOften present · Electrical

Knob-and-tube wiring

Many houses wired before about 1940 started out with single wires strung on porcelain knobs, no ground wire, and insulation that is now more than 80 years old.

Houses built
1945 or earlier
Dates from
Approximate era: Dates are an approximate era drawn from trade and reference sources.
How common
No reliable count exists
Priority
Check first
Mainly about
Safety
Where to look
Attic · Basement & foundation · Wiring & outlets · Electrical panel

What it is

Knob-and-tube was the standard way to wire a house from about 1880 into the 1940s: separate cloth-covered wires run on ceramic knobs and through ceramic tubes, with no ground. The insulation gets brittle with age, and the US Department of Energy says active knob-and-tube should be replaced before insulation is added around it. Many houses were only partly rewired, so old runs can survive in walls and attics.

How sure the dates are

Approximate era: Dates are an approximate era drawn from trade and reference sources.

Dates are an approximate era drawn from trade and reference sources. What the labels mean

How common it is

No reliable count exists

A house wired between about 1900 and 1930 most likely started with it; how much is still live depends on later rewiring, which nobody tracks.

The years

Houses built in 1945 or earlier may have it. It is most likely in houses built 1900 to 1930.

Earliest
Before 1880No start date. It reaches back past 1880, where these records begin.
Most likely
1900–1930The years it is most common: the solid part of the band.
Latest
About 1945An approximate date. The change came gradually, so a few later houses may have it.
  • Solid: most likely years
  • Faded edge: approximate date
  • Sharp edge: legal or recall date
  • Hatched: protection missing
  • Check first

How to check

  1. In the unfinished basement ceiling or the attic, look for white ceramic knobs nailed to the joists and ceramic tubes passing through them.

  2. Look for two separate cloth-covered wires running several inches apart, rather than one plastic-sheathed cable.

  3. Supporting clues: push-button light switches, two-slot outlets and a fuse box.

  4. Modern cable at the panel does not rule it out, because knob-and-tube is often spliced in further along the circuit.

Where to look
  • Attic
  • Basement & foundation
  • Wiring & outlets
  • Electrical panel

What to do

If you find itHave a licensed electrician find out which circuits are still live, especially before adding insulation, and keep insulation off any live runs. Replacing those circuits is the usual fix. Talk to your insurer early: InterNACHI notes that many insurers refuse to cover active knob-and-tube.

Sources

3 verified sources, 1 primary. Each quote is copied word for word from the page linked.

  1. US Department of Energy, Building Technologies Program, "Energy Renovations: Insulation" guidePrimary source

    For fire safety, active knob-and-tube wiring should be replaced before your contractor begins the insulation project.

    energy.gov/sites/prod/files/2013/11/f5/insulation_gui… (opens in a new tab)
  2. InterNACHITrade reference

    in common use in North America from about 1880 to the 1940s

    nachi.org/knob-and-tube (opens in a new tab)
  3. WikipediaReference

    It was common in North America and Japan starting in the 1880s, remaining prevalent until the 1940s in North America

    en.wikipedia.org/wiki/Knob-and-tube_wiring (opens in a new tab)

A source misread, out of date or missing?Report an error on this page

Applies to houses built

Open the full report for a year to see everything else houses of that age have in common.

A guide to what to look for. Not an inspection.