Built without · Roof, walls & windows
Built before energy codes
The first US energy standard for buildings, ASHRAE 90, was published in 1975, so a house built before then was not built to any energy code.
- Houses built without it
- 1979 or earlier
- Dates from
- Approximate era: Dates are an approximate era drawn from trade and reference sources.
- How common
- No reliable count exists
- Priority
- Good to know
- Mainly about
- Comfort
- Where to look
- Attic · Exterior walls · Windows · Whole house
What it is
Before energy codes, insulation levels, window types and air sealing were up to the builder. Model codes followed from 1975, but states and localities are responsible for adopting and enforcing them, so dates vary by place. Many older houses have had insulation added since.
How sure the dates are
Approximate era: Dates are an approximate era drawn from trade and reference sources.Dates are an approximate era drawn from trade and reference sources. What the labels mean
How common it is
No reliable count existsNo reliable count exists of how many older houses have been upgraded. A house built before 1975 was built without any energy code.
The years
Houses built in 1979 or earlier were built without it, unless it has been added since. The gap is most common in houses built 1974 or earlier.
- Earliest
- Before 1880No start date. It reaches back past 1880, where these records begin.
- Most likely
- To 1974The years when houses most often went without it.
- Latest
- About 1979An approximate date. Places adopted the requirement at different times.
- Solid: most likely years
- Faded edge: approximate date
- Sharp edge: legal or recall date
- Hatched: protection missing
- Check first
Year predicts poorly
Many older houses have had this added since, so the build year says little about whether yours has it now. Check either way.
How to check
Look in the attic at the depth of insulation between and over the joists.
Check what kind of glass the windows have: single pane or double pane.
- Attic
- Exterior walls
- Windows
- Whole house
What to do
If it was never addedAn energy audit shows where the house loses heat. Air sealing and attic insulation usually come first, then wall insulation.
Sources
4 verified sources, 1 primary. Each quote is copied word for word from the page linked.
U.S. Department of EnergyPrimary source
energy.gov/sites/prod/files/2015/07/f24/Codes%20Fact%… (opens in a new tab)States and localities are responsible for building energy code adoption and implementation.
Wikipedia, ASHRAE 90.1Reference
en.wikipedia.org/wiki/ASHRAE_90.1 (opens in a new tab)The original standard, ASHRAE 90, was published in 1975.
Wikipedia, International Energy Conservation CodeReference
en.wikipedia.org/wiki/International_Energy_Conservati… (opens in a new tab)is a building code created by the International Code Council in 2000
Wikipedia, International Code CouncilReference
en.wikipedia.org/wiki/International_Code_Council (opens in a new tab)In 1994, BOCA, SBCCI, and ICBO merged to form the International Code Council (ICC)
A source misread, out of date or missing?Report an error on this page
Reports for houses built without it
Open the full report for a year to see everything else houses of that age have in common.
A guide to what to look for. Not an inspection.