Year Built

Often present · Fire & life safety

Uncoated brass gas appliance connectors

Old flexible brass gas connectors behind stoves, dryers and water heaters can crack, and CPSC linked them to 35 deaths.

Houses built
1986 or earlier
Dates from
Court record: Dates come from a court settlement or a product recall.
How common
No reliable count exists
Priority
Worth a look
Mainly about
Safety
Where to look
Kitchen · Water heater · Heating & cooling

What it is

CPSC warned in 1996 that uncoated brass connectors, not made for at least the previous 10 years, can crack or break, citing 200 failures associated with 35 deaths and 59 injuries. A connector is usually replaced along with its appliance, so they survive mainly with very old gas appliances. Modern connectors are stainless steel or plastic-coated.

How sure the dates are

Court record: Dates come from a court settlement or a product recall.

Dates come from a court settlement or a product recall. What the labels mean

How common it is

No reliable count exists

Connectors are usually replaced with the appliance.

The years

Houses built in 1986 or earlier may have it.

Earliest
Before 1880No start date. It reaches back past 1880, where these records begin.
Most likely
Not narrowedSources give no narrower window, so treat every year in the range alike.
Latest
About 1986An approximate date. The change came gradually, so a few later houses may have it.
  • Solid: most likely years
  • Faded edge: approximate date
  • Sharp edge: legal or recall date
  • Hatched: protection missing
  • Check first

How to check

  1. CPSC says not to move a gas appliance to look; check only where the connector is already visible.

  2. An old connector is a dull brass-colored corrugated tube with no gray or yellow plastic coating.

  3. Modern connectors are stainless steel or coated.

Where to look
  • Kitchen
  • Water heater
  • Heating & cooling

What to do

If you find itHave a qualified gas technician check the connectors on older appliances and replace any uncoated brass one. A connector should never be reused.

Sources

2 verified sources, 2 primary. Each quote is copied word for word from the page linked.

  1. CPSC (release 97-003, dated 10 October 1996)Primary source

    older, uncoated, brass connectors, which have not been made for at least the past 10 years

    cpsc.gov/Newsroom/News-Releases/1997/CPSC-Warns-About… (opens in a new tab)
  2. CPSC (release 97-187, 9 September 1997)Primary source

    These gas connectors are made of brass, are uncoated, and can crack or break

    cpsc.gov/Newsroom/News-Releases/1997/CPSC-Urges-Consu… (opens in a new tab)

A source misread, out of date or missing?Report an error on this page

Applies to houses built

Open the full report for a year to see everything else houses of that age have in common.

A guide to what to look for. Not an inspection.