Year Built

Often present · Plumbing

High-flow toilets and showerheads

Since 1994, new toilets can use only 1.6 gallons per flush, less than half the water of most models in use before then.

Houses built
1993 or earlier
Dates from
Federal rule: Dates come from a federal rule or a model building code.
How common
No reliable count exists
Priority
Good to know
Mainly about
Cost
Where to look
Bathroom

What it is

Under the Energy Policy Act of 1992, toilets made from 1994 can use no more than 1.6 gallons per flush, and showerheads no more than 2.5 gallons per minute. A house built before 1994 that still has its original fixtures uses more water. Nothing here is unsafe; it is a water bill question.

How sure the dates are

Federal rule: Dates come from a federal rule or a model building code.

Dates come from a federal rule or a model building code. What the labels mean

How common it is

No reliable count exists

Toilets and showerheads are replaced often, so many older houses already have newer ones.

The years

Houses built in 1993 or earlier may have it.

Earliest
Before 1880No start date. It reaches back past 1880, where these records begin.
Most likely
Not narrowedSources give no narrower window, so treat every year in the range alike.
Latest
1993A fixed date, such as a ban, a recall or a code change.
  • Solid: most likely years
  • Faded edge: approximate date
  • Sharp edge: legal or recall date
  • Hatched: protection missing
  • Check first

How to check

  1. Lift the toilet tank lid: the gallons per flush is usually stamped or printed inside the tank, or on the bowl behind the seat, with a manufacture date.

  2. '1.6 gpf / 6.0 Lpf' or lower means it meets the 1994 rule.

  3. No marking and a large tank suggest a pre-1994 toilet.

Where to look
  • Bathroom

What to do

If you find itIf you want lower water bills, replace with a WaterSense-labeled toilet and showerhead, and check whether your utility offers a rebate.

Sources

3 verified sources, 2 primary. Each quote is copied word for word from the page linked.

  1. US House Subcommittee on Energy and Power, hearing on H.R. 623, 27 July 1999, Serial No. 106-76 (GovInfo)Primary source

    Since 1994, new toilets manufactured in the United States can only use 1.6 gallons of water per flush and showerheads are permitted to use only 2.5 gallons of water per minute.

    govinfo.gov/content/pkg/CHRG-106hhrg58509/html/CHRG-1… (opens in a new tab)
  2. US EPA WaterSensePrimary source

    less water than the current federal standard of 1.6 gallons per flush

    epa.gov/watersense/residential-toilets (opens in a new tab)
  3. WikipediaReference

    This law went into effect on January 1, 1994, for residential buildings and January 1, 1997, for commercial buildings.

    en.wikipedia.org/wiki/Low-flush_toilet (opens in a new tab)

A source misread, out of date or missing?Report an error on this page

Applies to houses built

Open the full report for a year to see everything else houses of that age have in common.

A guide to what to look for. Not an inspection.