Year Built

Often present · Hazardous materials

Lead solder in copper water pipes

Copper water pipes installed before mid-1986 were commonly joined with lead solder, and EPA says solder and old brass fixtures are the most common lead source in homes without a lead service line.

Houses built
1930–1988
Dates from
Federal rule: Dates come from a federal rule or a model building code.
How common
No reliable count exists
Priority
Worth a look
Mainly about
Safety
Where to look
Water pipes · Kitchen · Bathroom · Water heater

What it is

The 1986 Safe Drinking Water Act amendments banned solder with more than 0.2% lead in drinking-water plumbing after June 19, 1986, and gave states 24 months to enforce it. Pipes and fittings could still contain up to 8% lead until the limit dropped to a 0.25% weighted average in January 2014. You cannot reliably tell lead solder by eye; a water test is the practical check.

How sure the dates are

Federal rule: Dates come from a federal rule or a model building code.

Dates come from a federal rule or a model building code. What the labels mean

How common it is

No reliable count exists

No reliable count exists of how many houses built before the ban still have lead-solder joints.

The years

Houses built from 1930 to 1988 may have it. It is most likely in houses built 1986 or earlier.

Earliest
About 1930An approximate date. It came in gradually, and sources differ by a few years.
Most likely
To 1986The years it is most common: the solid part of the band.
Latest
1988A fixed date, such as a ban, a recall or a code change.
  • Solid: most likely years
  • Faded edge: approximate date
  • Sharp edge: legal or recall date
  • Hatched: protection missing
  • Check first

How to check

  1. Look at exposed copper pipe joints in the basement, at the water heater or under sinks. Old lead solder is dull gray and lead-free solder is brighter silver, but age blurs the difference.

  2. A lead swab test kit on a cleaned joint gives a better answer.

  3. The most reliable check is a first-draw water test through your utility or a certified lab.

Where to look
  • Water pipes
  • Kitchen
  • Bathroom
  • Water heater

What to do

If you find itTest your water. If lead shows up, run the cold tap before drinking, use cold water for cooking, and use a filter certified to NSF/ANSI 53 for lead. Replacing old brass faucets with post-2014 ones helps; repiping for solder alone is rarely needed.

Sources

8 verified sources, 7 primary. Each quote is copied word for word from the page linked.

  1. US EPA (2015 public webinar summary and submitted comments on SDWA section 1417 regulations)Primary source

    The main effect of this amendment, effective Jan. 4, 2014, will be to change the SDWA’s definition of lead free for pipes and pipe-fittings from “containing not more than 8.0 percent lead,”

    epa.gov/sites/production/files/2015-08/documents/impl… (opens in a new tab)
  2. US EPAPrimary source

    At the time "lead free” was defined as solder and flux with no more than 0.2% lead and pipes with no more than 8%.

    epa.gov/sdwa/use-lead-free-pipes-fittings-fixtures-so… (opens in a new tab)
  3. US EPAPrimary source

    Among homes without lead service lines, the most common problem is with brass or chrome-plated brass faucets and plumbing with lead solder.

    epa.gov/ground-water-and-drinking-water/basic-informa… (opens in a new tab)
  4. US Code, 42 USC 300g-6 (govinfo, 2010 edition)Primary source

    any solder, or any flux, after June 19, 1986, in the installa-

    govinfo.gov/content/pkg/USCODE-2010-title42/pdf/USCOD… (opens in a new tab)
  5. US EPA, Use of Lead Free Pipes, Fittings, Fixtures, Solder, and Flux for Drinking WaterPrimary source

    In 2011 Congress passed the Reduction of Lead in Drinking Water Act (RLDWA) revising the definition of lead free by lowering the maximum lead content of the wetted surfaces of plumbing products

    epa.gov/sdwa/use-lead-free-pipes-fittings-fixtures-so… (opens in a new tab)
  6. US EPA, 2025 update to the 7th DWINSA (fact sheet)Primary source

    With the latest data from 2025, EPA estimates that there are 4 million lead service lines across the country.

    epa.gov/system/files/documents/2025-11/fact-sheet-202… (opens in a new tab)
  7. US EPAPrimary source

    Lead pipes are more likely to be found in older cities and homes built before 1986.

    epa.gov/lead/protect-your-family-sources-lead (opens in a new tab)
  8. InterNACHI (Residential Plumbing Overview course text, 2012)Trade reference

    Copper is the most common water service pipe material, and has been used since the 1930s.

    nachi.org/documents2012/Residential_PLUMBING_Overview… (opens in a new tab)

A source misread, out of date or missing?Report an error on this page

Applies to houses built

Open the full report for a year to see everything else houses of that age have in common.

A guide to what to look for. Not an inspection.